HDT-IVECO

Installation is very basic for the HDT-IVECO module.
First locate ECU on the front of the tractor on the left hand side if you are siting in the cab. Next plug the HDT-IVECO Module in-between the ECM and factory harness. After this you need to will need to connect a red wire to 12V power source and black one to chassis ground.

This is considered a "piggy back unit" which means we use our own injector drivers to capture the injector signal from the ECU, modify it, then send the signal to the injector. This is different than many other products since we do not try to fool the ECU into thinking the air temp. is colder or just by simply adding a fuel pressure increase.

  The HDT-IVECO Module is pre-set to provide an additional 30% power increase from your stock H.P. setting. These units are adjustable between 15-45% power increase. You can simply connect the HDT-IVECO module into the Harness & GO!


Please include your Model, Year, & Engine size when ordering.

  • Item #: HDT-IVECO

HDT-IVECO

Price: $1,499.00
* Marked fields are required.
Qty: *